As always, when we develop a product, we test the conditions for a new product with optimal functionality and then begin in accordance with our development budget. There were no real limitations for the TA-5000.

we could draw on wide resources. The objective was to rethink everything for which an optimal solution did not yet exist on the market.

The Bearings
Even with this, one supposes there are already enough ball bearings. However, tone arms have a very tricky peculiarity. A tone arm should guide the needle flawlessly and not create any friction – neither horizontally nor vertically. At best, it should not present any bearing clearance or friction. This does not work mutually.

If there is clearance, then there is friction and vice versa. The ball bearing for horizontal and vertical movement ultra high precision Hybrid bearings made from hard steel and Ceramics. Only the best of what is delivered make it into the TA-5000. These bearings, are then meticulously adjusted and incorporated always from the same experienced specialist. Even here, we attempt to achieve the demand for zero clearance and zero friction. We provide both bearings with a little bit of pre-stress that eliminates clearance and nevertheless maintains extremely low friction. You can´t see all the efforts we make - but you can easily hear it.

The Armtube
The tone arm tube on a tone arm should be as stiff and light as possible and, at the same time, damping. Until now this has been impossible. Either it was stiff and light like carbon but without any damping and with a tendency towards resonances within listening frequency. Aluminum tubes and magnesium die
casting are relatively stiff but heavy and also hardly damping. Or it was made of esoteric mixtures and material combinations which were rumored to have tremendous properties until tested. A true solution that verifiably combined all the conflicting features did not yet exist. At the TA-5000 we use a combination of Different materials which are bonded with damping elements between the 2 tubes.

The Result
An innovative Armtube concept combined with pretensioned Hybrid bearings ensure that the TA-5000 is a perfect host for any cartridge mounted. The TA-5000 will perfectly guide the cartridge in the groove.



Technical Data:

 TOTAL LENGTH  9 inch  252 mm
   10 inch  270.2 mm
   12 inch  330.66 mm
 EFFECTIVE DISTANCE  9 inch  237 mm
   10 inch  254 mm
   12 inch  318.1 mm
 MOUNTING DISTANCE  9 inch  222 mm
   10 inch  237.8 mm
   12 inch  295.6 mm
 TILT ANGLE  9 inch  22.00 degree
   10 inch  21.60 degree
   12 inch  17.30 degree
 EFFECTIVE MASS  9 inch  12.4g
   10 inch  13.1g
   12 inch  14.4g
 MOUNTING HOLES  SME style, also available with Rega mounting as a option